Se-Kure Controls LE PLUS Instruções de Operação descarregar pdf (Página 3)

Page 3

Rectangular

Adhesive Pad

SK-905

Fig. 4

Fig. 5

Sensor Connections: – To Splitters & Strips

9. Insert a sensor’s modular plug into a splitter or strip port. Repeat this procedure until all

sensors have been plugged in.

Sensor Connections: – To Product (SK-904 Series Sensors)

10. Choose a small flat area on the back of the product where the sensor is to be applied.

VERY IMPORTANT!

NOTE: Clean the area on the product and the sensor with Alcohol Prep Pads.

Wipe these surfaces DRY with a clean paper towel. If the paper towel shows

dirt, REPEAT THIS CLEANING STEP until the surfaces are CLEAN & DRY!

11. Remove an SK-905 (1" x 2") Rectangular Adhesive Pad from its backing sheet. Apply

the adhesive pad to the bottom of the sensor, making sure that the center hole of the adhe-

sive lines up with the plunger on the bottom of the sensor. (See Fig. 4 below).

12. Remove the backing sheet

from the other side of the

adhesive pad and position the

Rectangular Sensor over the

flat area of the product

previously cleaned.

Press the sensor firmly into

place to insure a proper bond, (as shown in Fig. 5 above). The light on the sensor will

change to RED when the sensor is applied correctly to the product

Clean &

Wipe Dry

Remove

Adhesive

Backing

NOTE: Shunt plugs are not required and must not be used on ME ter-

minals, when the ME system is activated, it will automatically detect and

monitor all the open ports and sensored ports connected to it.

SPECIAL NOTE: When a sensor is plugged into a strip or splitter port, the port light will turn

GREEN. (If it is a “Dangling” or open or improperly connected sensor, the LED Light on the sensor

will flash from RED to GREEN to RED . . . also, the Terminal and Bar Graph lights will flash).

Sensor Connections: – To Lenses (SK-943 Series Lens Sensor)

13. Insert the Tie-Wrap into the Lens Sensor as shown in Fig. 6, and wrap it

around the lens. Pull the Tie-Wrap tight, and cut off the excess with wire

cutters or scissors.

Sensor Connections: – To Cameras with Removable Lenses

(SKD-0443 Series Dual Sensor)

14. The Dual Sensor, (shown in Fig. 7)

is a combination of the Rectangular Sensor and the Lens Sensor for

cameras with removable lenses. Follow Steps 9 thru 13 for installa-

tion procedures.

SK-943T Tie-Wrap

SKD-0443

Dual Sensor

SK-943

Tie Sensor

Fig. 6

Fig. 7

1 2 3 4 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários

Se-Kure Controls LE PLUS Instruções de Operação Página 3

Comentários a estes Manuais